UNISONIC TECHNOLOGIES CO., LTD LOW NOISE ma LDO REGULATOR DESCRIPTION The UTC is a typical LDO (linear regulator) with the features of High output voltage accuracy, low supply current, low ON-resistance, and high ripple rejection. During operation of the UTC, the dropout voltage is very low and the response of line transient and load transient are very well. Internally, there re many functions of UTC which can be seen in the block figure. There are a voltage reference unit, an error amplifier, resistor-net for voltage setting, a current limit circuit, and a chip enable circuit in each UTC. The UTC can be used as an ideal of the power supply for hand-held communication equipment, such as: power source for portable communication equipment, power source for electrical appliances, for example, cameras, VCRs and camcorders and power source for battery-powered equipment. FEATURES * Ultra Supply Current: 8µA (Typ.) * Standby Mode:.µA (Typ.) * Very Low Dropout Voltage:.V (Typ.) @I =5mA, V =.85V * : 75dB (Typ.) @f=khz,v =.85V * Temperature-Drift of : ±ppm/ C (Typ.) * Well :.%/ V (Typ.) * Accuracy: ±.8% (Typ.) * Internal Fold Back Protection Circuit: ma (Typ.) @ short mode * C =C =µf or more (Ceramic capacitors) are Recommended to be used with this IC ORDERG FORMATION Ordering Number Package Packing G-xx-AF5-R SOT-5 Tape Reel Note: xx:, refer to Marking Information. of Copyright Unisonic Technologies Co., Ltd
MARKG PACKAGE VOLTAGE CODE MARKG SOT-5 6:.6V :.V 5:.5V J:.85V :.V :.V Voltage Code SBXX 5 L: Lead Free G: Halogen Free P CONFIGURATION P DESCRIPTIONS P NO. P NAME DESCRIPTION V DD Input Pin GND Ground Pin CE Chip Enable Pin. Active when this Pin is high. NC No Connection 5 V Output Pin UNISONIC TECHNOLOGIES CO., LTD of
BLOCK DIAGRAM V DD V - + Reference Voltage Current Limit CE GND UNISONIC TECHNOLOGIES CO., LTD of
ABSOLUTE MAXIMUM RATG PARAMETER SYMBOL RATGS UNIT Input Voltage V 6. V Input Voltage(CE Pin) V CE 6. V V -.~ V +. V Output Current I ma Power Dissipation P D mw Junction Temperature T J +5 С Operating Temperature T OPR -~+85 С Storage Temperature T STG -55~+5 С Note: Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied. ELECTRICAL CHARACTERISTICS (Ta=5 С, V =Set V +V, I =ma, C I =C O =µf, unless otherwise specified) -.6V V V = Set V +V.587.6 V ma I 5mA mv Output Current I ma Supply Current I SS I =A 8 5 µa Short Current Limit I LIMIT V =V ma Output Noise en B W =Hz to khz, I =ma µvrms V =Set V +V, I =ma (In case that V =.V, V =V) Dropout Voltage V D I =5mA..8 V ΔV Set V +.5V V 5V.. %/V Temperature ΔV - С T OPR 85 С ± ppm/ С UNISONIC TECHNOLOGIES CO., LTD of
ELECTRICAL CHARACTERISTICS(Cont.) -.V V V = Set V +V.98.6 V ma I 5mA mv Output Current I ma Supply Current I SS I =A 8 5 µa Short Current Limit I LIMIT V =V ma Output Noise en B W =Hz to khz, I =ma µvrms V =Set V +V, I =ma (In case that V =.V, V =V) Dropout Voltage V D I =5mA.7. V ΔV Set V +.5V V 5V.. %/V Temperature ΔV - С T OPR 85 С ± ppm/ С -.5V V V = Set V +V.8.56 V ma I 5mA mv Output Current I ma Supply Current I SS I =A 8 5 µa Short Current Limit I LIMIT V =V ma Output Noise en B W =Hz to khz, I =ma µvrms V =Set V +V, I =ma (In case that V =.V, V =V) Dropout Voltage V D I =5mA..5 V ΔV Set V +.5V V 5V.. %/V Temperature ΔV - С T OPR 85 С ± ppm/ С UNISONIC TECHNOLOGIES CO., LTD 5 of
ELECTRICAL CHARACTERISTICS(Cont.) -.85V V V = Set V +V.8.866 V ma I 5mA mv Output Current I ma Supply Current I SS I =A 8 5 µa Short Current Limit I LIMIT V =V ma Output Noise en B W =Hz to khz, I =ma µvrms V =Set V +V, I =ma (In case that V =.V, V =V) Dropout Voltage V D I =5mA.. V ΔV Set V +.5V V 5V.. %/V Temperature ΔV - С T OPR 85 С ± ppm/ С -.V V V = Set V +V.98.6 V ma I 5mA mv Output Current I ma Supply Current I SS I =A 8 5 µa Short Current Limit I LIMIT V =V ma Output Noise en B W =Hz to khz, I =ma µvrms V =Set V +V, I =ma (In case that V =.V, V =V) Dropout Voltage V D I =5mA.. V ΔV Set V +.5V V 5V.. %/V Temperature ΔV - С T OPR 85 С ± ppm/ С UNISONIC TECHNOLOGIES CO., LTD 6 of
ELECTRICAL CHARACTERISTICS(Cont.) -.V V V = Set V +V.8.6 V ma I 5mA mv Output Current I ma Supply Current I SS I =A 8 5 µa Short Current Limit I LIMIT V =V ma Output Noise en B W =Hz to khz, I =ma µvrms V =Set V +V, I =ma (In case that V =.V, V =V) Dropout Voltage V D I =5mA.. V ΔV Set V +.5V V 5V.. %/V Temperature ΔV - С T OPR 85 С ± ppm/ С Note: Max. Input Voltage is 5.5V during 5hours UNISONIC TECHNOLOGIES CO., LTD 7 of
TEST CIRCUIT I SS V DD CE UTC -xx GND V.µF.µF TYPICAL APPLICATION CIRCUIT UNISONIC TECHNOLOGIES CO., LTD 8 of
TYPICAL CHARACTERISTICS. vs. Output Current.5 vs. Temperature (V =V)..., V (V).6..8. V =V V =V V =5V 5 5 5 5 Output Current, I (ma), V (V)....99.98.97.96.95 - - - - 5 6 7 8 9 Temperature, T OPR ( С) 5 Dropout Voltage vs. Output Current Input Transient Response Dropout Voltage, VD (mv) 5 5 5 5 Ta=5 C 5 5 Output Current, I (ma), V (V) mv/div Input Voltage I =ma t R = t F = 5µs 6 8 6 8.. Input Voltage, V (V) Load Transient Response Load Transient Response, V (V) mv/div 5 Output Current 5mA ma 5 Output Current, I (ma) V =V V =V 6 8 6 8 6 8 6 8, V (V) 5mV/div Output Current ma 5mA Output Current, I (ma) UNISONIC TECHNOLOGIES CO., LTD 9 of
TYPICAL CHARACTERISTICS(Cont.), V (V) Turn On Speed With CE Pin I =ma 6 6 8 Time, t(µs), VCE (V), V (V) Turn On Speed With CE Pin I =ma 6 8 6, VCE (V), V (V) Turn On Speed With CE Pin I =5mA 6 6 8, VCE (V), V (V) Turn Off Speed With CE Pin I = ma 5 5 5, VCE (V), V (V) Turn Off Speed With CE Pin I = ma 5 5 5, VCE (V), V (V) Turn Off Speed With CE Pin I = 5mA 5 5 5, VCE (V) UNISONIC TECHNOLOGIES CO., LTD of
UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UNISONIC TECHNOLOGIES CO., LTD of