() PRELIMINARY
CONTENTS Page Key 3 Dimensions and Specifications Crane Dimensions 4 Specifications 5 Range Diagram 6 Load Charts 7 Technical Descriptions Lifting Capacity 8 Boom and Components 8 Jib 8 Winch Performance 9 Crane Boom Function Speeds 9 Outrigger Function Speeds 9 Outrigger Controls 9 Engine and Transmission 10 Hydraulics 10 Chassis and Components 11 Driver Cab 11 Operator Cab 11 2
KEY Counterweight Outrigger Radius Main boom Boom length Boom with extension Boom angle Tip height Hook block Slewing / Allowable swinging range / Working speeds Working temperature Main hoist Auxiliary hoist Hoist speed Cab Engine Steering Travel speed Hydraulics Transmission Load limiter / Load indicator Air conditioning / Cab heating / Gradeability road 3
CRANE DIMENSIONS 4
SPECIFICATIONS Crane Weights Gross vehicle weight (GVW) (GVW) 32,400 kg Axle Loads Steering axle (axle 1) (1) Drive axles (axle 2 and 3) (23) 7,130 kg 25,270 kg Ground Clearances Minimum ground clearance 267 mm Ramp angle 15.9 Approach angle 18.4 Departure angle 13.6 Wheel Base Distance between axle 1 and 2 12 Distance between axle 2 and 3 23 4,225 mm 1,350 mm Wheel Track Axle 1 1 Axle 2 and 3 23 2,069 mm 1,830 mm Outrigger Dimensions Longitudinal span Transverse span 5,030 mm 6,100 mm Outrigger Forces Maximum counterforce 337 kn Overall Dimensions (Length x Width x Height) ( x x ) 12.41 m x 2.50 m x 3.43 m 5
RANGE DIAGRAM 6
LOAD CHARTS 1m 13 13.5 14 14.5 15 15.5 16 16.5 17 18 19 10 11 12 13 14 15 16 18 20 22 24 26 28 30 Fully extended (100%) 360 10.25 m 25000 25000 24500 22000 20000 18000 16000 14200 12900 11000 13.85 m 23000 22000 20500 19000 17700 16000 14000 12700 10900 8900 7200 6000 Main boom Boom Boom length angle 17.45 m 22.85 m 28.25 m 33.65 m 39.05 m kg 80 78 18000 76 17000 12000 74 15700 12000 10000 72 14700 11500 9500 70 13700 10900 9000 68 12800 10400 8500 7000 66 12000 9800 8000 6800 64 10600 8800 7600 6300 5200 62 8800 8000 6800 5800 5000 60 7100 7300 6200 5300 4800 58 5800 6600 5700 4900 4500 56 4850 5500 5250 4500 4150 54 4100 4800 4900 4200 3850 52 3450 4100 4500 3950 3580 50 3500 3950 3700 3350 45 3050 3450 3350 3150 2280 2500 2750 2750 2050 2200 2300 1550 1700 1850 1400 1450 1060 1150 900 700 Boom + Jib 39.05 m + 8.3 m + 39.05 m + 8.3 m Jib angle 1 30 3000 2850 2850 2800 2700 2600 2450 2200 2000 1750 1500 1280 1080 920 760 600 290 Parts of Line 8 8 6 5 4 3 3 1 1 min. 0 0 0 0 25 35 36 45 45 1900 1900 1800 1750 1700 1600 1500 1420 1350 1280 1210 1100 960 850 700 550 260 Notes The values in table are rated lifting capacities of crane on solid ground and in a level state. The working radius in the table are actual radius after load lifting. While lifting with boom length of 10.25 m each section must be fully retracted. The tabulated load ratings includes weight of hooks, main hook is 300 kg and auxiliary hook is 70 kg. While the jib is in extension state the rated load capacity lifted by main boom must be reduced by 400 kg. When the main hook is at the head of main boom: lifting with jib, the lifting capacities of jib must be reduced by 300 kg; When working with head pulley, the rated lifting capacities at each section must be reduced by 300 kg, but max. lifting capacities is 3000 kg; Using main hook when auxiliary hook at the head of pulley of the boom tip, the rated lifting weight of each pant of lifting boom should be reduced by 70 kg. When the fi fth outrigger is not in use, no lifting in front of 120 range. On the fi fth outrigger, according to the tabulated rated lifting capacities in 360 range. If the boom length exceeds the specifi ed values, comparing it s capacities with the next longer one s, the load to the lift whill be with in the smaller one s. The bottom column in the table lists all min. boom angle of elevation in various boom length. Elevating the boom below the corresponding min. angle of elevation is strictly for bidden. 10.25 m 300 kg70 kg400 kg 300 kg300 kg 3000 kg70 kg 120 360 7
TECHNICAL DESCRIPTIONS Lifting Capacity Maximum rated capacity for main hook 25 t Maximum rated capacity for auxiliary hook 3 t Maximum load moment 980 kn.m Boom and Components Profi le Octagon Number of sections 5 Base boom length 10.25 m Base boom maximum lift height 10.46 m Base boom maximum working radius 8 m Fully extended boom length 39.05 m Fully extended boom maximum lift height 39.19 m Fully extended boom maximum working radius 30 m Jib Fully extended boom maximum lift height with jib 48.4 m Fully extended boom maximum working radius with jib 32 m Slewing speed 02.0 rpm 8
TECHNICAL DESCRIPTIONS Winch Performance Main hoist 3rd layer single rope speed 0125 m/min Auxiliary hoist 2nd layer single rope speed 0125 m/min Crane Boom Function Speeds Elevation up 50 sec Elevation down 50 sec Full extension 90 sec Full retract 90 sec Outrigger Function Speeds Simultaneous full extension 50 sec Simultaneous full retract 60 sec Outrigger Controls Dual outrigger controls LH and RH side Dual control Ambient working temperature 20 C +40 C 9
TECHNICAL DESCRIPTIONS Engine and Transmission Weichai power WP7.300E40 Emission compliance National Exhaust Standard IV Number of cylinders 6 Aspiration Turbocharged Rated power 220 kw @ 2300 rpm Maximum torque 1100 Nm @ 1200 1600 rpm Estimated fuel consumption per 100 km 100 km 36 L Fuel type Diesel Fuel tank capacity 270 L Lowest start temperature 30 C Manual gearbox Manual shift Hydraulics Load sensing hydraulic system Load sensing Combined system with dual pump Double pump Choice of hydraulic controls: Pilot actuated multiaxis joystick controls Pilot joystick 10
TECHNICAL DESCRIPTIONS Chassis and Components Axle drive system 6 x 4 Fifth outrigger for 360 boom operation Fifth outrigger 360 Minimum turning radius 10 m Maximum gradeability 39 % Maximum traveling speed 75 km/h Driver Cab Adjustable driver seat Adjustable steering wheel Airconditioner and heater Operator Cab Adjustable seat Load moment limiter display Airconditioner and heater 11
www.terexcranes.com Effective Date: October 2011. Product specifi cations and prices are subject to change without notice or obligation. The photographs and/or drawings in this document are for illustrative purposes only. Refer to the appropriate Operator s Manual for instructions on the proper use of this equipment. Failure to follow the appropriate Operator s Manual when using our equipment or to otherwise act irresponsibly may result in serious injury or death. The only warranty applicable to our equipment is the standard written warranty applicable to the particular product and sale and Terex makes no other warranty, express or implied. Products and services listed may be trademarks, service marks or tradenames of Terex Corporation and/or its subsidiaries in the USA and other countries. All rights are reserved. Terex is a registered trademark of Terex Corporation in the USA and many other countries. Copyright 2011 Terex Corporation. 201110/ / /Terex 2011, Terex (China) Investment Co., Ltd 8th Floor, Tower B, GATEWAY, No. 18 Xiaguangli, North Road, East 3rd Ting, Chaoyang District, Beijing, 100027 China Phone: +86 10 5907 9000, Fax: +86 10 8440 0628, Email: cranes@terex.com, Web: www.terexcranes.com 100027 : +86 10 5907 9000, :+86 10 8440 0628, : cranes@terex.com, : www.terexcranes.com Sichuan Changjiang Engineering Crane Co., Ltd Qiancao, Luzhou, Sichuan Tel: 08303581773, Fax: 08303582242, Email: cranes@terex.com, Web: www.terexcranes.com : 08303581773, : 08303582242, : cranes@terex.com, : www.terexcranes.com Brochure Reference: TCDSME/C 10.11 : TCDSME/C 10.11