1.ai

Transcription

1 HDMI camera ARTRAY CO,. LTD

2

3

4 Introduction Thank you for purchasing the ARTCAM HDMI camera series. This manual shows the direction how to use the viewer software. Please refer other instructions or contact our sales representatives About a hardware. This is for ARTCAM HDMI camera series. Please read other instructions for other series. Every series has its own installation or setting instructions. (USB2.0 series, Serial ATA camera series etc...) This is the manual for the viewer software to sell in Japan. All right is reserved by ARTRAY Co., Ltd. This is strongly prohibited by law to reprint all or parts of the contents without permission. All names of program, system and CPU are trademarks of each retailer. Copyright(c)2009 Artray Co., Ltd.

5

6 Follow the steps below to install attached CD to your PC. Viewer software Device driver StepInstall a device driver for USB2.0 camera. (If you are done this step before, ignore and go to step 2) * Please use internal USB 2.0 port. Recommended PCIntel chip setpc above ICH5. Install device driver Choose a folder drivers (See page 5 for installing to Windows XP, and page 7 for Windows VISTA Step 2Install viewer software setup.exein thefolder, and install the software. (See page 9 for installing View an imagecamera set upcalibration View the image from a camera, set up calibration.

7

8

9

10 The window below is shown when install is done propery. Click Close. The word It is ready to use a device is pop up. At the Windows 2000 and XP, you had to install default driver both (farmware) and driver(software). But at the Windows Vista, you can install all at onece. At the Windows Vista, driver would be autmatically installed if you change the connected USB port. (At the Windows 2000 and XP, you had to re-install a driver). How to check if installing device driver is succeed. STARTControl PanelDevice ManagerM When you open a device manager window, user account control panel as likewould be pop up. Click Continue. Check if camera name Artray ARTCAM-022-MINI is shown under the Universal Sirial Controller (USB) tree.

11

12

13 Step3View an imagecamera / Calibaration setting Make sure a lens is set on the ARTCAM camera. Connect to USB2.0 PORT in your PC. For 2 camera mode, please connect 2 same cameras to an USB port. the viewer software. Viewer software[startprogramsart-viewer-cd-v****-enar-viewer] Camera setting dialog is open. And current connected camera is shown. ARTCAM-150P3-MOUT is shown for ARTCAM-150P4-HDMI device driver. ARTCAM-130MI VGA is shown for ARTCAM-130MI-HDMI device driver. Click Start and the software screen is shown. 1 camera mode If you connect the camera after start up the software, Click Update button to update the camera connecting condition. Check mark *Don t show this message again and click Start, And this window is not shown from next time. If you want to show this dialog again, go to Software settings Design settings And check a mark on Display camera setting Make sure the camera you connected is shown on the Camwindow. And Click START cameras mode Connect 2nd camera to the USB2.0 ports. Click camera mode, and choose Device1 Device2from Cam1 and Cam2. Then click START (This 2 camera views are not for same correspondence) Go to Software settings 2camera mode settings And check a mark on When 2 cameras are connected, boot up as a 2 camera mode

14

15

16

17

18

19

20

21

22

23

24 Setting ARTCAM-130MI-HDMI ARTCAM-150P4-HDMI ARTCAM-130MI-MOUT-DUAL ARTCAM-150P4-MOUT-DUAL

25

26

27

28

29