untitled

Size: px

Start display at page:

Download "untitled"

谖依尔觉罗
5 years ago
Views:

1 () PRELIMINARY

2 CONTENTS Page Key 3 Dimensions and Specifications Crane Dimensions 4 Specifications 5 Range Diagram 6 Load Charts 7 Technical Descriptions Lifting Capacity 8 Boom and Components 8 Jib 8 Winch Performance 9 Crane Boom Function Speeds 9 Outrigger Function Speeds 9 Outrigger Controls 9 Engine and Transmission 10 Hydraulics 10 Chassis and Components 11 Driver Cab 11 Operator Cab 11 2

3 KEY Counterweight Outrigger Radius Main boom Boom length Boom with extension Boom angle Tip height Hook block Slewing / Allowable swinging range / Working speeds Working temperature Main hoist Auxiliary hoist Hoist speed Cab Engine Steering Travel speed Hydraulics Transmission Load limiter / Load indicator Air conditioning / Cab heating / Gradeability road 3

4 CRANE DIMENSIONS 4

5 SPECIFICATIONS Crane Weights Gross vehicle weight (GVW) (GVW) 32,400 kg Axle Loads Steering axle (axle 1) (1) Drive axles (axle 2 and 3) (23) 7,130 kg 25,270 kg Ground Clearances Minimum ground clearance 267 mm Ramp angle 15.9 Approach angle 18.4 Departure angle 13.6 Wheel Base Distance between axle 1 and 2 12 Distance between axle 2 and ,225 mm 1,350 mm Wheel Track Axle 1 1 Axle 2 and ,069 mm 1,830 mm Outrigger Dimensions Longitudinal span Transverse span 5,030 mm 6,100 mm Outrigger Forces Maximum counterforce 337 kn Overall Dimensions (Length x Width x Height) ( x x ) m x 2.50 m x 3.43 m 5

6 RANGE DIAGRAM 6

7 LOAD CHARTS 1m Fully extended (100%) m m Main boom Boom Boom length angle m m m m m kg Boom + Jib m m m m Jib angle Parts of Line min Notes The values in table are rated lifting capacities of crane on solid ground and in a level state. The working radius in the table are actual radius after load lifting. While lifting with boom length of m each section must be fully retracted. The tabulated load ratings includes weight of hooks, main hook is 300 kg and auxiliary hook is 70 kg. While the jib is in extension state the rated load capacity lifted by main boom must be reduced by 400 kg. When the main hook is at the head of main boom: lifting with jib, the lifting capacities of jib must be reduced by 300 kg; When working with head pulley, the rated lifting capacities at each section must be reduced by 300 kg, but max. lifting capacities is 3000 kg; Using main hook when auxiliary hook at the head of pulley of the boom tip, the rated lifting weight of each pant of lifting boom should be reduced by 70 kg. When the fi fth outrigger is not in use, no lifting in front of 120 range. On the fi fth outrigger, according to the tabulated rated lifting capacities in 360 range. If the boom length exceeds the specifi ed values, comparing it s capacities with the next longer one s, the load to the lift whill be with in the smaller one s. The bottom column in the table lists all min. boom angle of elevation in various boom length. Elevating the boom below the corresponding min. angle of elevation is strictly for bidden m 300 kg70 kg400 kg 300 kg300 kg 3000 kg70 kg

8 TECHNICAL DESCRIPTIONS Lifting Capacity Maximum rated capacity for main hook 25 t Maximum rated capacity for auxiliary hook 3 t Maximum load moment 980 kn.m Boom and Components Profi le Octagon Number of sections 5 Base boom length m Base boom maximum lift height m Base boom maximum working radius 8 m Fully extended boom length m Fully extended boom maximum lift height m Fully extended boom maximum working radius 30 m Jib Fully extended boom maximum lift height with jib 48.4 m Fully extended boom maximum working radius with jib 32 m Slewing speed 02.0 rpm 8

9 TECHNICAL DESCRIPTIONS Winch Performance Main hoist 3rd layer single rope speed 0125 m/min Auxiliary hoist 2nd layer single rope speed 0125 m/min Crane Boom Function Speeds Elevation up 50 sec Elevation down 50 sec Full extension 90 sec Full retract 90 sec Outrigger Function Speeds Simultaneous full extension 50 sec Simultaneous full retract 60 sec Outrigger Controls Dual outrigger controls LH and RH side Dual control Ambient working temperature 20 C +40 C 9

10 TECHNICAL DESCRIPTIONS Engine and Transmission Weichai power WP7.300E40 Emission compliance National Exhaust Standard IV Number of cylinders 6 Aspiration Turbocharged Rated power rpm Maximum torque rpm Estimated fuel consumption per 100 km 100 km 36 L Fuel type Diesel Fuel tank capacity 270 L Lowest start temperature 30 C Manual gearbox Manual shift Hydraulics Load sensing hydraulic system Load sensing Combined system with dual pump Double pump Choice of hydraulic controls: Pilot actuated multiaxis joystick controls Pilot joystick 10

11 TECHNICAL DESCRIPTIONS Chassis and Components Axle drive system 6 x 4 Fifth outrigger for 360 boom operation Fifth outrigger 360 Minimum turning radius 10 m Maximum gradeability 39 % Maximum traveling speed 75 km/h Driver Cab Adjustable driver seat Adjustable steering wheel Airconditioner and heater Operator Cab Adjustable seat Load moment limiter display Airconditioner and heater 11

12 Effective Date: October Product specifi cations and prices are subject to change without notice or obligation. The photographs and/or drawings in this document are for illustrative purposes only. Refer to the appropriate Operator s Manual for instructions on the proper use of this equipment. Failure to follow the appropriate Operator s Manual when using our equipment or to otherwise act irresponsibly may result in serious injury or death. The only warranty applicable to our equipment is the standard written warranty applicable to the particular product and sale and Terex makes no other warranty, express or implied. Products and services listed may be trademarks, service marks or tradenames of Terex Corporation and/or its subsidiaries in the USA and other countries. All rights are reserved. Terex is a registered trademark of Terex Corporation in the USA and many other countries. Copyright 2011 Terex Corporation / / /Terex 2011, Terex (China) Investment Co., Ltd 8th Floor, Tower B, GATEWAY, No. 18 Xiaguangli, North Road, East 3rd Ting, Chaoyang District, Beijing, China Phone: , Fax: , cranes@terex.com, Web: : , : , : cranes@terex.com, : Sichuan Changjiang Engineering Crane Co., Ltd Qiancao, Luzhou, Sichuan Tel: , Fax: , cranes@terex.com, Web: : , : , : cranes@terex.com, : Brochure Reference: TCDSME/C : TCDSME/C 10.11

Terex Cranes, Material & Telehandlers Crane.Market

Terex Cranes, Material & Telehandlers Crane.Market TRUCK CRANE 汽车起重机 DATASHEET METRIC 数据表 ( 公制 ) CONTENTS 目录 Page 页码 : Key 关键词汇.... 3 Dimensions and Specifications 技术参数 Crane Dimensions 起重机外形尺寸..... 4 Specifications 规格参数..... 5 Range Diagram 起升高度.....