APPLI002.DOC

Transcription

1 SIEGET 25 Silicon Bipolar- Dielectric Resonator Oscillator (DRO) at 10 GHz Oscillators represent the basic microwave energy source for all microwave systems such as radar, communications and navigation. A typical oscillator essentially consists of an active device and a passive frequency-determining resonant element such as a dielectric resonator for fixed-frequency oscillators or a varactor for a tunable oscillator. The emphasis has been on high output-power, low noise, small size, low cost, high reliability and high temperature stability. The new SIEGET BFP405 (SIEMENS Grounded Emitter Transistor) offers now the extension of plastic packaged bipolar transistor oscillators up to 12 GHz (Fig.1). Figure 1. Lab-version of a parallel feedback stabilized oscillator at 10 GHz. This DRO is shown without top-plate, tuning screw and blocking capacitor 1 pf. Semiconductor Group 1 Edition A03,

2 There are two categories of fixed oscillators: serial feedback and parallel feedback. For serial feedback the transistor gain must be higher, because the coupling from the resonator to the microstrip-line isn't that strong and also the emitter cannot be directly connected to the ground potential. Therefore the parallel feedback configuration is a good choice. Highly selective positive feedback between base and collector of the transistor can be used to create stable oscillations. This is achieved by feeding back part of the output signal into the input signal. There are two conditions for oscillation: 1) open-loop phase shift at f 0 has to be 2πn n= 0,1,2... 2) open-loop small signal gain must exceed unity At oscillator start up, the loop gain is greater than one with phase of 2πn. As the signal levels build up from noise, limiting take place and steady state condition is reached. 100 pf 18 kohms 10 kohms BFP405 opt. 27 Ohms Oscillator-DC-Schematic +3V 1 pf Dielectr. resonator B69500-A9107 SIEMENS Res. frequency: 9.1 GHz Temp. coeff.: 0.0 ppm/k Qual. factor: 4400 Dielectr. constant: 38.0 RF - OUTPUT RF - OUTPUT 28.3mm 1 pf BFP405 Q62702-F1592 SIEMENS SMA-connector 27 Ohms 100 pf +3V 18 kohms 10 kohms Figure 2. Layout of the silicon DRO on a PTFE-board ε r ( = 2.45, h= 0.38 mm, t=17.5 µm copper). Semiconductor Group 2 Edition A03,

3 The 10 GHz-oscillator in figure 1/2 exhibits at 50 Ω an output-power of +3 dbm, a phase noise of typical < - 80 dbc/hz at 10 khz offset and a temperature stability unoptimized of ± 3 MHz at -20 C to 60 C. The operating voltage of + 3V causes a device current of 8 ma. The biasing circuit uses a 27 Ω collector resistor and a base resistor of 10 kω and 18 kω. Please keep in mind, that the feedback from base to the +3V-pad and to the collector port of the transistor has to be minimized by filtering (Fig.2) or by using an active biasing circuit. Fig.3 shows the simulated harmonics versus frequency of the oscillator described above. Figure 3. By using the nonlinear parameters of the BFP405 and a CAD-program (Microwave Harmonica) one can easily determine the harmonics of the oscillator. Semiconductor Group 3 Edition A03,

4 A new dc-bias-circuit shows better stability (Fig.4). The oscillator exhibits a phase-noise of -85 dbc/hz at 10 khz offset (Fig.5/6). By using a spacer a 15 db reduction of the phase noise can be achieved. DR BFP405 22k nF RF-Out 1nF 100pF +5V 28 mm Teflon Board: Taconic, er=2.45, h=0.38mm, t=17.5um Cu 22 mm Scale 1:1 Fig. 4 Layout and Schematic of the DRO-Redesign Out BFP405 1nF 10nF 22k 270 DRO-Schematic 100pF +5V Semiconductor Group 4 Edition A03,

5 Fig. 5 Phase Noise plot Fig. 6 Spectrum-Analyzer plot 10 GHz DRO Semiconductor Group 5 Edition A03,

6 References [1] S. Hamilton, "Microwave Oscillator Circuits," Microwave Journal, 1978, April, p [2] Guillermo Gonzalez: Microwave Transistor Amplifiers, Prentice-Hall, Inc., [3] G.D. Vendelin, A.M. Pavio, U.L.Rohde: Microwave Circuit Design, John Wiley and Sons, [4] K.Kurokawa,"Noise in Synchronized Oszillators," IEEE Trans. Microwave Theory Tech., Vol.Mtt-16, April 1968, p [5] E.C.Niehenke, P.A. Green," A low-noise Dielectric Resonator Stabilized Microstrip Oscillator," MTT-S-International Microwave Symposium, 1987, p [6] Allen A. Sweet: MIC and MMIC Amplifier and Oscillator Circuit Design, Artech House Boston, London, [7] E.C. Niehenke, R.D. Hess,"A Microstrip low-noise X-Band Voltage- Controlled Oscillator," IEEE Trans. Microwave Theory and Techniques, Vol.MTT-27, No 12, Dec. 1979, p [8] G. Lohninger, "Oszillatordesign in der Hochfrequenztechnik," Elektronik, 05/95. Jan 95, HL EH PD 1, G. Lohninger Published by Siemens AG, Bereich Bauelemente, Vertrieb, Produkt-Information, Balanstraße 73, D München Siemens AG All Rights Reserved As far as patents or other rights of third parties are concerned, liability is only assumed for components per se, not for applications, processes and circuits implemented within components or assemblies. The information describes the type of component and shall not be considered as assured characteristics. Terms of delivery and rights to change design reserved. For questions on technology, delivery and prices please contact the Offices of Semiconductor Group in Germany or the Siemens Companies and Representatives world-wide (see address list). Due to technical requirements components may contain dangerous substances. For information on the type in question please contact your nearest Siemens Office, Semiconductor Group. Siemens AG is an approved CECC manufacturer. Semiconductor Group 6 Edition A03,

7 易迪拓培训 专注于微波 射频 天线设计人才的培养网址 : 射频和天线设计培训课程推荐 易迪拓培训 ( 由数名来自于研发第一线的资深工程师发起成立, 致力并专注于微波 射频 天线设计研发人才的培养 ; 我们于 2006 年整合合并微波 EDA 网 ( 现已发展成为国内最大的微波射频和天线设计人才培养基地, 成功推出多套微波射频以及天线设计经典培训课程和 ADS HFSS 等专业软件使用培训课程, 广受客户好评 ; 并先后与人民邮电出版社 电子工业出版社合作出版了多本专业图书, 帮助数万名工程师提升了专业技术能力 客户遍布中兴通讯 研通高频 埃威航电 国人通信等多家国内知名公司, 以及台湾工业技术研究院 永业科技 全一电子等多家台湾地区企业 易迪拓培训课程列表 : 射频工程师养成培训课程套装该套装精选了射频专业基础培训课程 射频仿真设计培训课程和射频电路测量培训课程三个类别共 30 门视频培训课程和 3 本图书教材 ; 旨在引领学员全面学习一个射频工程师需要熟悉 理解和掌握的专业知识和研发设计能力 通过套装的学习, 能够让学员完全达到和胜任一个合格的射频工程师的要求 课程网址 : ADS 学习培训课程套装该套装是迄今国内最全面 最权威的 ADS 培训教程, 共包含 10 门 ADS 学习培训课程 课程是由具有多年 ADS 使用经验的微波射频与通信系统设计领域资深专家讲解, 并多结合设计实例, 由浅入深 详细而又全面地讲解了 ADS 在微波射频电路设计 通信系统设计和电磁仿真设计方面的内容 能让您在最短的时间内学会使用 ADS, 迅速提升个人技术能力, 把 ADS 真正应用到实际研发工作中去, 成为 ADS 设计专家... 课程网址 : HFSS 学习培训课程套装该套课程套装包含了本站全部 HFSS 培训课程, 是迄今国内最全面 最专业的 HFSS 培训教程套装, 可以帮助您从零开始, 全面深入学习 HFSS 的各项功能和在多个方面的工程应用 购买套装, 更可超值赠送 3 个月免费学习答疑, 随时解答您学习过程中遇到的棘手问题, 让您的 HFSS 学习更加轻松顺畅 课程网址 : `

8 易迪拓培训 专注于微波 射频 天线设计人才的培养网址 : CST 学习培训课程套装该培训套装由易迪拓培训联合微波 EDA 网共同推出, 是最全面 系统 专业的 CST 微波工作室培训课程套装, 所有课程都由经验丰富的专家授课, 视频教学, 可以帮助您从零开始, 全面系统地学习 CST 微波工作的各项功能及其在微波射频 天线设计等领域的设计应用 且购买该套装, 还可超值赠送 3 个月免费学习答疑 课程网址 : HFSS 天线设计培训课程套装套装包含 6 门视频课程和 1 本图书, 课程从基础讲起, 内容由浅入深, 理论介绍和实际操作讲解相结合, 全面系统的讲解了 HFSS 天线设计的全过程 是国内最全面 最专业的 HFSS 天线设计课程, 可以帮助您快速学习掌握如何使用 HFSS 设计天线, 让天线设计不再难 课程网址 : MHz NFC/RFID 线圈天线设计培训课程套装套装包含 4 门视频培训课程, 培训将 13.56MHz 线圈天线设计原理和仿真设计实践相结合, 全面系统地讲解了 13.56MHz 线圈天线的工作原理 设计方法 设计考量以及使用 HFSS 和 CST 仿真分析线圈天线的具体操作, 同时还介绍了 13.56MHz 线圈天线匹配电路的设计和调试 通过该套课程的学习, 可以帮助您快速学习掌握 13.56MHz 线圈天线及其匹配电路的原理 设计和调试 详情浏览 : 我们的课程优势 : 成立于 2004 年,10 多年丰富的行业经验, 一直致力并专注于微波射频和天线设计工程师的培养, 更了解该行业对人才的要求 经验丰富的一线资深工程师讲授, 结合实际工程案例, 直观 实用 易学 联系我们 : 易迪拓培训官网 : 微波 EDA 网 : 官方淘宝店 : 专注于微波 射频 天线设计人才的培养易迪拓培训官方网址 : 淘宝网店 :