Terex Cranes, Material & Telehandlers Crane.Market

Size: px

Start display at page:

Download "Terex Cranes, Material & Telehandlers Crane.Market"

沈洽蜜贝
4 years ago
Views:

1 TRUCK CRANE 汽车起重机 DATASHEET METRIC 数据表 ( 公制 )

2 CONTENTS 目录 Page 页码 : Key 关键词汇 Dimensions and Specifications 技术参数 Crane Dimensions 起重机外形尺寸 Specifications 规格参数 Range Diagram 起升高度 Load Charts 起重量表 Technical Descriptions 技术描述 Lifting Capacity 起重量... 8 Boom and Components 主臂和零件... 8 Jib 副臂... 8 Winch Performance 起升机构工作速度... 9 Crane Boom Function Speeds 起重臂工作速度... 9 Outrigger Function Speeds 支腿工作速度... 9 Outrigger Controls 支腿操纵... 9 Engine and Transmission 发动机和变速箱 Hydraulics 液压系统 Chassis and Components 底盘及其部件 Driver Cab 驾驶室 Operator Cab 操纵室

3 KEY 关键词汇 Counterweight 配重 Outrigger 支腿 Radius 作业半径 Main boom 主臂 Boom length 吊臂长度 Boom with extension 副臂 Boom angle 吊臂角度 Tip height 臂尖高度 Hook block. 吊钩总成 Slewing / Allowable swinging range 回转 / 回转范围 Working speeds 作业速度 Main hoist 主起升机构 Auxiliary hoist. 副起升机构 Hoist speed 起升速度 Cab 驾驶室 Engine. 发动机 Steering. 转向 Travel speed 行驶速度 Hydraulics 液压装置 Transmission. 变速箱 Air conditioning / Cab heating 空调 / 取暖器 Gradeability road 爬坡度公路 Working temperature 作业温度 3

4 CRANE DIMENSIONS 起重机外形尺寸 4

5 SPECIFICATIONS 规格参数 Crane Weights 起重机总重量 Gross vehicle weight (GVW) 车辆总重量 (GVW). 26,700 kg Axle Loads 桥负荷 Steering axle (axle 1) 转向桥.( 桥.1). Drive axles (axle 2 and 3) 驱动桥.( 桥.2. 和.3). 7,600 kg 19,100 kg Ground Clearances 通过性参数 Minimum ground clearance 最小离地间隙. 281 mm Ramp angle 纵向通过角 Approach angle 接近角 Departure angle 离去角 Wheel Base 轴距 Distance between axle 1 and 2 桥.1. 和.2. 之间的距离. Distance between axle 2 and 3 桥.2. 和.3. 之间的距离. 4,225 mm 1,350 mm Wheel Track 轮距 Axle 1. 桥.1. Axle 2 and 3 桥.2. 和.3. 2,088 mm 1,800 mm Outrigger Dimensions 支腿跨距 Longitudinal span 纵向跨距. Transverse span 横向跨距 m 6.0 m Outrigger Forces 支腿反力 Maximum counterforce 最大支反力. 296 kn Overall Dimensions 外形尺寸 (Length x Width x Height) ( 长 x 宽 x 高 ) m x 2.5 m x m 5

6 RANGE DIAGRAM 起升高度 6

7 LOAD CHARTS 起重量表 Fully extended 支腿全伸 (100 %) 360 1m Parts of Line. 倍率 m m m m kg m m m m Parts of Line. 倍率 Notes 说明 The values in table are rated lifting capacities of crane on solid ground and in a level state. The working radius in the table are actual radius after load lifting. The values above the bold line are based on crane strength, those below the bold line are based on crane stability. While lifting with boom length of m each section must be fully retracted. The tabulated load ratings includes weight of hooks, main hook is 300 kg and auxiliary hook is 100 kg. While the jib is in extension state the rated load capacity lifted by main boom must be reduced by 400 kg. When the main hook is at the head of main boom: lifting with jib, the lifting capacities of jib must be reduced by 300 kg; When working with head pulley, the rated lifting capacities at each section must be reduced by 300 kg, but max. lifting capacities is 2500 kg; Using main hook when auxiliary hook at the head of pulley of the boom tip, the rated lifting weight of each pant of lifting boom should be reduced by 100 kg. When the fifth outrigger is not in use, no lifting in front of 120 range. On the fifth outrigger, according to the tabulated rated lifting capacities in 360 range. If the boom length exceeds the specified values, comparing it s capacities with the next longer one s, the load to the lift whill be with in the smaller one s. 表中的数据为坚硬地面上水平状态下的额定起重量表中的作业半径是负载起吊后的实际半径粗线上的数据基于起重机的强度, 粗线下的数据基于起重机的稳定性使用 m. 长的起重臂起吊时, 各节臂必须处于完全缩回状态表中的负载值包括了吊钩的种类, 主钩是.300 kg, 副钩是.100 kg 在副臂处于完全伸出状态时, 主臂的起重量必须减去.400 kg 当主钩位于主臂头部时 : 使用副臂起吊时, 副臂的起重量必须减去.300 kg; 使用臂端单滑轮作业时, 各部分的起重量必须减去.300 kg, 但是最大起重量是.2500 kg; 在副钩位于臂端单滑轮的情况下使用主钩时, 起重臂各部分的额定起重重量必须减少.100 kg 当不使用第五个支腿时, 在.120. 的范围前面不能起吊在第五个支腿上, 根据表中.360. 范围中的额定起重量进行确定如果臂长超过的规定的数据, 使用下一个较长的比较其起重量, 起重的负荷将为较小的一个 7

8 TECHNICAL DESCRIPTIONS 技术描述 Lifting Capacity 起重量 Maximum rated capacity for main hook 主钩额定起重量 20 t Maximum rated capacity for auxiliary hook 副钩额定起重量. 2.5 t Maximum load moment 最大起重力矩. 838 kn.m Boom and Components 主臂和零件 Profile 截面形状. Hexagonal 六边形. Number of sections. 节数. 4 Base boom length 基本臂长度 m Base boom maximum lift height 基本臂最大起升高度 m Base boom maximum working radius 基本臂最大作业半径 8 m Fully extended boom length. 全伸臂长度 31.7 m Fully extended boom maximum lift height. 全伸臂最大起升高度 m Fully extended boom maximum working radius. 全伸臂最大作业半径. 24 m Jib 副臂 Length of fully extended boom and fully extended jib. 主臂副臂完全伸出的长度 39.7 m Fully extended boom maximum lift height with jib. 安装副臂最大起升高度 m Fully extended boom maximum working radius with jib.. 安装副臂最大作业半径 32 m Slewing speed 回转速度 rpm 8

9 TECHNICAL DESCRIPTIONS 技术描述 Winch Performance 起升机构工作速度 Main hoist 3rd layer single rope speed 主卷扬.. 第三层.. 单绳速度 m/min Auxiliary hoist 2nd layer single rope speed 辅卷扬.. 第二层.. 单绳速度. 098 m/min Crane Boom Function Speeds 起重臂工作速度 Elevation up 起臂. 85 sec Elevation down 落臂. 75 sec Full extension 全伸. 85 sec Full retract 全缩. 45 sec Outrigger Function Speeds 支腿工作速度 Simultaneous full extension 同步伸出. 45 sec Simultaneous full retract 同步收缩. 50 sec Outrigger Controls 支腿操纵 Dual outrigger controls LH and RH side 支腿操纵.. 左侧和右侧. Dual control 两侧操纵 Ambient working temperature 作业温度. 20 C +40 C 9

10 TECHNICAL DESCRIPTIONS 技术描述 Engine and Transmission 发动机和变速箱 Weichai power 潍柴动力. WP Emission compliance 排放标准. National Exhaust Standard III 国家排放标准.III Number of cylinders 缸数. 6 Aspiration 进气. Turbocharged 涡轮增压 Rated power 额定功率 rpm Maximum torque 最大扭矩 rpm Estimated fuel consumption per 100 km 100 km. 油耗. 45 L Fuel type 燃油类型. Diesel 柴油 Fuel tank capacity 燃油箱容积 270 L Lowest start temperature 最低启动温度.. 40 C Manual gearbox with ZF style airboosted shifting ZF 气动助力式手动变速箱. Manual airboosted shift 气动助力式手动变速 Hydraulics 液压装置 Combined system with dual pump 带有双泵的组合系统. Double pump 双泵 Hydraulic controls: 液压控制 : Mechanical, multilever controls 机械式, 多杆控制. Mechanical lever Option 机械杆.. 选装 10

11 TECHNICAL DESCRIPTIONS 技术描述 Chassis and Components 底盘及其部件 Axle drive system 桥驱动系统. 6 x 4 Fifth outrigger for 360 boom operation Fifth outrigger 360 作业的第五支腿. 第五支腿 Minimum turning radius 最小转弯半径. 11 m. Maximum gradeability. 最大爬坡度.. 28 % Maximum traveling speed 最高行驶速度. 77 km/h Driver Cab 驾驶室 Adjustable driver seat 可调式司机座椅. Adjustable steering wheel 可调式方向盘. Airconditioner and heater 空调和加热装置 Operator Cab 操纵室 Adjustable seat 可调式座椅. Load moment limiter display 载荷力矩限制装置的显示. Airconditioner and heater 空调和加热装置 11

12 Powered by TCPDF ( Effective Date: August Product specifications and prices are subject to change without notice or obligation. The photographs and/or drawings in this document are for illustrative purposes only. Refer to the appropriate Operator s Manual for instructions on the proper use of this equipment. Failure to follow the appropriate Operator s Manual when using our equipment or to otherwise act irresponsibly may result in serious injury or death. The only warranty applicable to our equipment is the standard written warranty applicable to the particular product and sale and Terex makes no other warranty, express or implied. Products and services listed may be trademarks, service marks or tradenames of Terex Corporation and/or its subsidiaries in the USA and other countries. All rights are reserved. Terex is a registered trademark of Terex Corporation in the USA and many other countries. Copyright 2010 Terex Corporation. 生效日期 :2010 年 8 月产品技术参数和价格如有更改, 恕不另行通知本文档中的图片和 / 或图纸仅作举例用途有关正确使用本设备的说明, 请参阅合适的操作手册如果在使用本设备时, 未按照操作手册正确操作, 可导致严重的人身伤害或死亡适用于我们设备的唯一保证是适用于特别产品和销售的标准书写保证, 特雷克斯不做任何其他保证表示或暗示以上所列产品和服务为特雷克斯公司和 / 或其子公司在美国和其他国家 / 地区的商标服务标记或厂商名称保留所有版权 Terex. 为特雷克斯公司在美国和许多其他国家的注册商标 2010, 特雷克斯公司版权所有 Terex Cranes, Global Marketing, Dinglerstraße 24, Zweibrücken, Germany Tel. +49 (0) , info.cranes@terex.com, 特雷克斯起重机, 全球销售, 德国 Dinglerstraße 24, Zweibrücken 电话 :+49 (0) , info.cranes@terex.com, Brochure Reference: TCDSME/CLT1020/ 手册参考 : TCDSME/CLT1020/

untitled

untitled () PRELIMINARY CONTENTS Page Key 3 Dimensions and Specifications Crane Dimensions 4 Specifications 5 Range Diagram 6 Load Charts 7 Technical Descriptions Lifting Capacity 8 Boom and Components 8 Jib 8