Product Specification Document Description Ext. PSU Model Number 66MS-00120500-S01-V Revision A0 Notes -
E. C. LIST/ 变更记录 Rev. 版本 Description of Change/ 变更内容描述 Before/ 变更前 After/ 变更后 Changed Date/ 日期 Remark A B C D E Contents/ 目录 1. SCOPE/ 概述...3 2. Input Characteristics/ 输入特性...3 3. Output Characteristics/ 输出特性...3 4. Protection Requirements/ 保护要求...4 5. Environment Requirements/ 环境要求...4 6. EMC/ Safety Standards/EMI/EMS 标准...4 7. Testing Equipment / 测试设备 5 8. Label Drawing/ 标贴图...5 9. Outline Drawing/ 外观图... 6 10. Package Drawing/ 包装示意图 7 Page 2 of 7
1. SCOPE/ 概述 The document details the electrical, mechanical and environmental specifications of a SMPS, the power supply provides60w continuous output power. 资料详细描述了一款 60W( 连续输出功率 ) 开关电源的电气性, 结构性及环境等要求. The power supply shall meet the RoHS requirements. 此款电源符合 RoHS 要求. SMPS Adaptor(Wall mount)/ 插墙式适配器 SMPS Adaptor(Desk-top)/ 桌面型适配器 Open Frame/ 开放式结构 Others/ 其他 2. Input Characteristics/ 输入特性 2.1. Input Voltage & Frequency/ 输入电压与频率 Minimum/ 最小 Rating/ 额定值 Maximum/ 最大 Input Voltage/ 输入电压 90Vac 100Vac~240Vac 264Vac Input Frequency/ 输入频率 50Hz 60Hz/50Hz 63Hz 2.2. Input AC Current / 输入电流 15Amax. @ 180Vac input & Full load/ 在 180Vac 输入和满载条件下最大 1.5A 2.3. Inrush Current (cold start)/ 浪涌电流 ( 冷启动 @ 230V AC) No damage for 220V/50Hz at cold start (25 ). 在冷开机条件下, 最大浪涌电流对机型不损坏. 2.4. Average Efficiency / 平均效率 While input 115Vac and 230Vac,the average efficiency is more than87 %.The test point is at 25%,50%,75% and 100% of max load respectively. 在输入 115Vac 和 230Vac 条件下, 平均效率不小于 87% 测试点分别是最大载的 25%,50%,75% 100% 2.5. Standby power / 空载功耗 Standby power <0.5W @ 230VAC/50Hz. 在输入 230Vac, 空载功耗小于 0.5W. 和 3. Output Characteristics/ 输出特性 RATED OUTPUT / 额定输出 Rated Load/ 额定负载 120mVp-p 7.6A Page 3 of 7 Min. Max. Output Voltage(unload) / 空载输出电压 11.4V 12.6V Output Voltage(Full load) / 负载输出电压 11.4V 12.6V Output Current / 输出电流规格 0A 5.0A Turn - on Delay Time/ 开机延迟时间 Hold-up Time/ 关机维持时间 Ripple & Nosic / 纹波与噪声 OCP / 过电流保护 power Wp-p / 峰值功率 5mS 3S Remark 备注 Ripple & Noise: Tested by a oscilloscope using 20MHz bandwidth and the output is paralleled a 0.1uF ceramic capacitor and a 47uF electrolysis capacitor.
4. Protection Requirements/ 保护要求 4.1. Over Current Protection/ 过流保护 OCP Point Limited: 120%-300% auto restart 保护点限制 : 120%-300% 自动保护 The output shall hiccup when the over current applied to the output, and shall be self-recovery when the fault condition is removed 当过电流时, 输出将进入打嗝模式, 当过流情况解除后, 产品将会自动恢复正常 4.2. Short Circuit Protection/ 短路保护 The input power shall decrease when the output is short to GND, the power supply shall not damage, and shall be self-recovery when the fault condition is removed 当输出对地短路时, 产品输入功率降低且不会损伤, 当短路情况解除后, 产品将会自动恢复正常 4.3. AC Over Voltage Protection/ 过压保护 ( 部分机型有此功能 ) The power supply shall protection when the input over voltage exceeds 300V, the power supply shall no damage, some models have this function. 当输入电压超过 300V 时, 产品保护且不会损伤, 部分机型有此功能 5. Environment Requirements/ 环境要求 5.1. Operating Temperature and Relative Humidity/ 操作温度和湿度要求 0 to +40 20%RH to 80%RH @ Sea level shall below or no more than10,000 feet 在海拔小于或等于 10,000 英尺的条件下, 低温工作下限为 0, 高温工作上限为 +40, 相对湿度为 20%RH to 80%RH 5.2. Storage Temperature and Relative Humidity/ 存储温度和湿度要求 -30 to + 70 10%RH to 90%RH(non-condensing)@ Sea level shall below 30,000 feet 在海拔低于 30,000 英尺的条件下, 低温存储下限为 -30 ( 无结冰环境 ); 高温存储上限为 +70, 相对 湿度为 10%RH to 90%RH 5.3. Vibration/ 振动 10 to 300Hz sweep at a constant acceleration of 1.0G(Breadth: 3.5mm) for 1Hour for each of the perpendicular axes X, Y, Z 扫描频率 : 10 to 300Hz, 加速度 : 1.0G( 位移 : 3.5mm), X, Y, Z 三垂直坐标轴向各振动 1 小时 6. EMC Standards & Safety Standards / EMC 标准与安规标准 6.1. EMC Standards/EMC 标准 GB9254 GB17625.1 GB13837 FCC- Part15 EN 55022 EN55024 CISPR 22 EN 61000-4-4 EN 61000-3-2 EN 61000-3-3 EN 61000-4-2 EN 61000-4-3 EN 61000-4-5 EN 61000-4-6 EN 61000-4-8 EN 61000-4-11 6.2. Safety Standards / 安规标准 Type Country Standard Type Country Standard CCC China GB4943 CE Europe EN60950-1 CCC China CB CB IEC60950 UL/CUL USA UL60950-1 C-TICK Australia KC Korea KC60950 GS/TUV German Page 4 of 7
6.3. ielectric Strength(Hi-pot)/ 介电耐压强度 ( 高压 ) Primary to Secondary: 1500Vac / 5mA / 60 seconds (3 seconds for production) 初级对次级 : 1500Vac / 5mA / 60 秒 ( 生产时高压测试时间 : 3 秒 ) 6.4. Leakage Current/ 漏电流 0.25mA max. at 240Vac / 50Hz input/ 在输入 240Vac/50Hz 的条件下最大 0.25mA 6.5. Insulation Resistance/ 绝缘阻抗 100MΩ min. @ primary to secondary add a 500Vdc test voltage 在初级与次级间加 500Vdc 进行测试, 最小 100MΩ 7. Testing Equipment / 测试设备 Testing Equipment / 测试设备 Model/ 型号 Validity/ 有效期 Remark/ 备注 1 AC Source / 交流输入电源 华仪 6205-300W 2 Power Meter / 电源功率计 Protronix-1201 3 Electronic Load / 电子负载 Chroma-63030C 4 Oscilloscopes / 示波器 泰克 3012 5 Digital Multimeter / 数字万用表 VC9807A 6 DC Power / 直流输入电源 KXN-3030D 7 HI-POT Tester / 耐压测试仪 华仪 7410 8 Hybrid Recorder / 混合记录仪 YOKOGAWA DR130 9 Cons. T/H Simulator / 恒温恒湿仪 TH-A4H 1-150 10 Insulation Resistance Tester / 绝缘电阻表 华仪 7410 8. Label drawing / 标贴图 Page 5 of 7
Page 6 of 7
10. Package Drawing / 包装图 66MS-00120500-S01-V Page 7 of 7