H/2 标志 30±1 H/2 标志 ±2 ±0.2 60± ±2 80.5±1 100±1 3 L1 L 3 L1 L 5.3± W~600W 800W M 400W 2R2-10K 600W 4R3-20K 800W 33K 10

Size: px

Start display at page:

Download "H/2 标志 30±1 H/2 标志 ±2 ±0.2 60± ±2 80.5±1 100±1 3 L1 L 3 L1 L 5.3± W~600W 800W M 400W 2R2-10K 600W 4R3-20K 800W 33K 10"

颟架边
5 years ago
Views:

1 d H/2 标志 5.3±0.2 H±1 A±1 250±10 L1 L Ability to tractive power of M 80W R50-4K3 100W R75-5K1 150W(160W) R75-6K8 200W 7K5 300W 8K2 L L A mm H d 按客户要求选配 P R Lead fetched out 引出导线

2 H/2 标志 30±1 H/2 标志 ±2 ±0.2 60± ±2 80.5±1 100±1 3 L1 L 3 L1 L 5.3± W~600W 800W M 400W 2R2-10K 600W 4R3-20K 800W 33K 1000W 43K 6R8-68K L L1 mm Ability to tractive power of P R Terminal 焊片

3 RXLG--F 40[B] W~150W 200W~600W 100 ± W Ability to tractive power of M RXLG--F 80W R47-2.7K RXLG--F 100W R75-3K RXLG--F 150W(160W) 5.1K RXLG--F 200W 7K5 RXLG--F 300W 1R6-7.5K L L mm d 按客户要求选配 P R Lead fetched out 引出导线

4 RXLG--T ±0.5 <200W 200W~600W Ability to tractive power of M RXLG--T 400W 2R2-10K RXLG--T 600W 4R3-20K RXLG--T 800W 36K RXLG--T 1000W 43K RXLG--T 6R8-51K L L mm d P R Terminal 焊片

5 Technology parameter of type RXLG aluminous crust resistor RXLG 铝外壳电阻器技术参数 1. Electric and mechanical capability: 电气机械性能 : Serial number 序号 Item 测试项目 Resistance and resistance variance 电阻值以及变化范围 Resistor temperature Coefficient Rating load 额定负载 Short term overload 短时过载 Withstand voltage 耐压 Terminal strength 焊片强度 ibration proof 振动 Capability require 性能 Superficial temperature 375 表面温度 375 No abnormality ΔR ±(2R+0.05) 无异常 ΔR ±(2R+0.05) No abnormality M 无异常 M No abnormality no destroying ΔR ±( 0.1R+0.05) 无异常无破坏 ΔR ±( 0.1R+0.05) No abnormal or Loosing 无异常无松动 No abnormal ΔR ±(0.1R+0.05) 无异常 ΔR ±(0.1R+0.05) Test method 测试方法 Accordance with JIS-C 遵守 JIS-C To run within temperature range 25~200, factor shall be in accordance with JIS-C 在 25~200 温度下实验, 遵守 JIS-C Correctly mounted on mm plate aluminium,accordance with JIS-C 放置在 mm 铝板上, 遵守 JIS-C Application of 10 times higher than rating power for 5 seconds under the same invironment, accordance with JIS-C 同样环境下,10 倍额定功率,5 秒, 遵守 JIS-C shall be 100 M or more between terminal and case when measured with DC 500 insulation resistance tester, accordance with JIS-C 直流 500, 焊片和外壳之间的要求大于或等于 100M, 遵守 JIS-C No abnormality shall be found when AC 2500 applied between terminal and case for 1 min, accordance wirh JIS-C 焊片与外壳之间加交流电压 2500, 1 分钟, 遵守 JIS-C A static load of 100N in the direction of terminal for 30 seconds, accordance to JIS-C (1) 100N 力加在焊片引出方向,30 秒, 遵守 JIS-C (1) No mechanical damage shall be observed where vibration applied in a cycle of 10~55HZ 1.5mm wide in the three directions for 1 minute, keeping 2 hours in each direction. Accordance with JIS-C ~55 HZ,1.5mm 振幅, 三个方向, 一个周期 1 分钟每个方向上持续 2 小时, 无机械损伤, 遵守 JIS-C

6 Technology parameter of type RXLG aluminous crust resistor RXLG 铝外壳电阻器技术参数 2.Endure capability: 耐久性 Serial number 序号 Item 测试项目 Heat tolerance 耐热性 Thermal shock 热冲击 Moisture resistance life 耐湿性 Capability require 性能 No colour changed and abnormality except terminal, sign clear 除焊片外, 无颜色明显变化, 标记清晰 No abnormality ΔR ±(2R+0.05) 无异常 ΔR ±(2R+0.05) No damage Sign clear ΔR ±(3R+0.05) R 25M 无损伤标记清晰 ΔR ±(3R+0.05) 绝缘阻值 R 25M Test method 测试方法 Where the device is heated to 350±5 with no load for 120±5 minutes, accordance with JIS-C 无负载, 加热至 350±5,120±5 分钟, 遵守 JIS-C Apply rating power for 30 minutes,on reaching thermal stability,within 8-12 s expose to -40±2 for 15+5 minutes, then constant temperature, 2 hours. accordance with JIS-C 分钟, 常温,8-12 秒放到 -40±2 环境下,15+5 分钟再在常温下放置 2 小时, 遵守 JIS-C DC voltage of 100 at 40±2 at relative humidity shall be applied for 1 hour, then cycled off for less than 0.5 hours,for hours, accordance with JIS-C 直流电压 100,40±2, 相对湿度 90-95,60 分钟开,30 分钟关, 持续小时, 遵守 JIS-C Load life 负载寿命 No damage Sign clear ΔR ±(5R+0.05) 无损伤标记清晰 ΔR ±(5R+0.05) Correctly mounted on mm plate aluminium, rating DC voltage shall be applied at 20±7, 90 minutes on 30 minutes off, then cycled for hours, accordance with JIS-C 放置在 mm 铝板上,20±7, 额定直流电压,90 分钟开,30 分钟关, 循环小时, 遵守 JIS-C 更改事项 : 短时过载 : 10 倍更改为 10 倍额定功率更改事由 : 原翻译错误

7 ±0.2 M 800W 1000W 沈阳东芝 1K 5R0-30K 1500W 6R8-36K L L mm P R

8 Ability to tractive power of Terminal 焊片 RXLG-S1 φ ±1 L M RXLG-S1 1000W 10K RXLG-S1 15K RXLG-S1 1500W 2000W 1R6-2500W 2R5- L L mm P R

9 Ability to tractive power of Terminal 焊片

Thin Film Precision Temperature Chip Resistor TPT 2013.xls

Thin Film Precision Temperature Chip Resistor TPT 2013.xls FEATURE Thin Film Passivity NiCr Resistor Very Tight Tolerance from ±0.01%. Extremely Low TCR from ±5ppm/ Wide R-Value Range Rated : 1/32W ~ 1W (0402 ~2512) Applications Medical Equipment Testing / Measurement